Adventures in Spark Gaps

I wanted to build a spark gap transmitter—you know, for fun.  However, things didn’t start off so great.  Here is how it went down.

My first plan was to build this.

I like it, but it uses an ignition coil and some other thing.  However, check out the receiver.  That’s awesome.  It’s a coherer receiver (I think) and it basically detects a spark with those two bolts in the plastic sleeve.  There should be some iron filings or something in between the bolts.  When a spark is detected, the filings jump the gap and make it a conductor.  I’m not sure why the LED light is connected to a 9 volt battery though.

After that, I just did some google searches for spark gap transmitter and attempted to build the designs I saw.  None of them had capacitor values, so I just had to guess.  But they didn’t work.

I honestly thought I knew how to do this.  I tried a step up transformer with a capacitor.  Nope.  Actually, I was getting a spark on the battery side but not the step up voltage side.  How did I even pass physics courses?

Here is my attempt with a transformer.

Finally, I found a page that used an electromechanical bell.  That works.

I decided to build my own oscillator from scratch.

Homework (for me)

  • Make this more solid (the connection to the steel plate is iffy.
  • Could you replace the steel plate with a paperclip?
  • Can you change the buzzing frequency by adding weights to the oscillating bar?
  • Use a step up transformer to get BIGGER SPARKS.
  • What about an antenna?
  • Build a coherer detector.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s